|
|
|
Sliding Hood Caddy
The prop rod slildes up
and dow as you open and close your hood. In the up position
the prop rod lock with a thumb screw so the hood can't fall or be
knocked over. This also prevents the wind from knocking our
hood over. Rods are made from polished stainless steel with
polished aluminum ends. '28-'36 cars with three piece hood -
$129.00
'37 - '38 Ford - $129.00
|
|
|
|
Caddy for Four Piece Hoods
These caddies mount to
the upper corners of the firewall with 2 stainless steel studs and
with hold both sides of the hood up on most cars with 4 piece
hoods. The feature polished aluminum bodies with stainless
steel arms covered in vinyl at the ends. These spring loaded arms
pull out and lock in the up and down positions. -
$60.00
|
|
|
Inside Door Handle
(Ford or Mopar) Installation Kit
This kit makes it
easier to install door handles when using bear claw/rotary
latches. Kits are available for Ford and Mopar square shank. Kits
are spring loaded to return handle to original position. One kit
does 2 doors.
$60.00
|
|
|
Inside Door Handle
(GM) Installation Kit
This kit makes it
easier to install door handles when using bear claw/rotary
latches. Kits are available for GM spline shaft. Kits are spring
loaded to return handle to original position. One kit does 2 doors
$60.00
|
|
|
Outside Door
Handle Installation Kit
The outside kit bolts
into the door handle shank slides through it. It then connects tot
he latch by a linkage rod. One kit does 2 doors
$60.00
|
|
|
Resto GM Power
Window Switches
These power window
switches are designed for those who want to have power windows but
keep the resto look. After installing the window crank, you push
the crank slightly forward or rearward to raise or lower the
window. Round spline shaft. One kit does 2 doors.
$129.00
|
|
|
Resto Ford/Mopar
Power Window Switches
These power window
switches are designed for those who want to have power windows but
keep the resto look. After installing the window crank, you push
the crank slightly forward or rearward to raise or lower the
window. Square shank shaft. One kit does 2 doors.
$129.00
|
|
|
Electric Suicide
Door Safety Pin & Door Lock Kit
Suicide safety pin door
kits are a necessity for safety on cars with suicide doors. This
standard kit includes 2 safety pins without switches. These are
intended to be used as door locks actuated by remotes to lock the
doors from the outside or inside. The deluxe kit includes switches
and wiring pigtails to be used instead of remotes to actuate the
pins from the inside to act as safety pins. Both kits include snap
in dress bushings for both the door and post, stainless steel
screws and instructions. One kit does both doors.
Standard Kit - $100.00
Deluxe Kit - $115.00
|
|
|
Suicide Door
Safety Pin Kit
Suicide safety pin door
kits are a necessity for safety on cars with suicide doors.
The kit is made of machined aluminum body with stainless steel
slide pin and knob shaft. Kit includes plastic snap-in dress
bushings for door jambs, stainless steel screws and instructions.
Black knobs are standard with each kit. Slide pin is spring loaded
in both the in and out position to keep it in place. Upgrade kit
with a warning light or beeper to alert you that the door has not
been latched. Available for Ford, Plymouth/Dodge and GM vehicles.
One kit does both doors.
Standard Kit - $65.00
Standard Plus Light - $70.00
Standard Plus Beeper - $75.00
|
|
|
Door Prop Rods
These door prop rods
are great for holding your doors open at car shows to show off
that great interior without having to worry about the wind blowing
your door or people stepping into your car. One end slips over the
striker bolt and locks into position, while the other end snaps
over your latch jaws. For use with rotary latches only. - $60.00
|
|
|
Stainless Steel
Latch Strikers
Stainless steel
strikers are available for those who prefer a substitute for the
standard steel strikers that come with bear claw or rotary
latches. Sizes are available for all popular door and trunk
latches.
Large Strikers (11/16) - $40.00
Medium (small) Strikers (9/16) - $40.00
Small (mini) Strikers (1/2) - $40.00
|
|
|
E Z Jump Kit
A safe sure way to jump
start your car if the battery ever fails with cars that have hard
to reach batteries. The jumper block is di-electric plastic
1-1/4" x 4". The small size allows installation just
about anywhere. The lead terminals are stamped "P" for
position and "N" for negative. Kit comes with 5 foot of
cable with crimped ends. - $65.00
|
|
